[SnowMN]

I used to remove, clean and repack my bearings ever season. Now I jack up the trailer, check wheel bearings for tightness - tighten if loose, check for grease seal leak, spin wheels and listen to bearings, if quiet and no leaks, just grease, until it starts to push, it out the front of the cap. Good to go. I have been doing this for 10 years now and no issues. I use to have 4 trailers with my Auction business and traveled the state, did the same with all of them and never had any issues.

I will probably follow something more similar to your approach in the future, but with the first maintenance on a new trailer I've always preferred to clean out all the factory grease and repack. Maybe unnecessary, but I like to know what grease is inside so I know there are no incompatibilities in grease type. After the 1st repack I will take advantage of the EZ-lubes.

 

[SnowMN]

I had a few minutes between family obligations so pulled the wheel off to answer my own question. I'll put the answer here in case it is ever searched by someone else.

The Dexter 3500lb EZ-lube axles use Dexter seal P/N 010-019-00. The bearings inside are L44649 & L68149.

 

[SnowMN]

If it's any help to you the seal part number crosses over to NAPA number 17144.
Lynn

Thanks. That's really helpful to know for the future.