Ski-Doo Snowmobiles Forum banner

Wiring Low beam to high

241 views 4 replies 3 participants last post by  76TNTRV 
#1 ·
Guys,

Looking for wiring diagram for my '05 PT so I can try jumping low beam to the high beam side and run both on in High beam position. If someone can post wiring diagram that would be greatly appreciated. Or if someone here has already done it please share the details of connector, pin out, etc.

Thanks
 
#3 ·
Why would you want to do that?
It will cause a high amp on the wiring and the stator /voltage regulator
plus if you ride trails at night passing someone the other way you blind the guy coming at you.
Not a smart idea in my eyes.
Rich
 
#4 ·
Rich,

It's jumped to the high beam side so that you have both high and low on in the high beam mode. Toggling back to low beam energizes low beam only...just like normal...
The additional amperage draw will not exceed stator output or wiring capabilty...I've done it before on my AC sleds.

Anybody have a diagram....
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top