Ski-Doo Snowmobiles Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3,286 Posts
Discussion Starter · #1 ·
I want to get a new (used) clutch for my sled.
N E 1 know if a 2005 600SDI clutch will fot on my 2005 800P'TEK ?
I would just take my guts and put them in the other clutch. I reall just want the faces off the 600 clutch. Thanks. I believe they are diff. part numbers but I though a TRA 3 was a TRA 3 ???
 

·
Just the Tip!!
Joined
·
2,504 Posts
They all fit the same but the angle of the sheaves might be alittle different but not much, i know for the 600's the Roller arms are bolted down on each side of each other and the 800's have an Allen screw running throw the bottom of the Roller arm with a nut on the end, what this means i do not know it doesnt say in the 2005 skidoo bible.
 

·
Premium Member
Joined
·
8,339 Posts
johnniev57 said:
I want to get a new (used) clutch for my sled.
N E 1 know if a 2005 600SDI clutch will fot on my 2005 800P'TEK ?
I would just take my guts and put them in the other clutch. I reall just want the faces off the 600 clutch. Thanks. I believe they are diff. part numbers but I though a TRA 3 was a TRA 3 ???
[snapback]744889[/snapback]​
Yes it should work, 800 clutch is forged and the 600 is cast. angles are the same. I ran a 600 clutch on my 1000 twin with no problems.
 
1 - 3 of 3 Posts
Top