Ski-Doo Snowmobiles Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
112 Posts
Discussion Starter · #1 ·
Hey guys,
I'm new to the rev chassis. I just bought an 04 mxz that I replaced the nun on. I'm putting it back together, and I can't figure out what these are/where they go.

This long wire is spliced back into itself, and runs back under the gas tank.
Hood Automotive tire Automotive lighting Motor vehicle Automotive design


These wires come out of the harness right by the wires for the DESS.
Automotive tire Hood Motor vehicle Automotive fuel system Automotive design
 

·
Registered
Joined
·
223 Posts
I would start by looking at the electrical diagram for your sled.
Follow the wire to a know point ex: stator, switch... and look at the diagram and figure where it should end.
You should find a shop manual for your sled here.

 

·
Registered
Joined
·
6,132 Posts
That is not a factory splice!

Bob
 

·
Registered
Joined
·
13,581 Posts
The wires in your first pic, you will have to follow them and see where they go, as bar says they're not factory and likely installed for an accessory. The wires in your second pic are for a sled with electric start, they are the control circuits for the starter solenoid that would be mounted on top of the battery box.
 
1 - 4 of 4 Posts
Top