Ski-Doo Snowmobiles Forum banner
1 - 7 of 7 Posts

·
stuck...
Joined
·
2,867 Posts
Discussion Starter · #1 ·
have to change rollers and need to remove gear bolt. what shold I touque it to. I also have a primary spring to put in so what do I tourqe the primary bolt to. 2008 600 sdi gade
 

·
stuck...
Joined
·
2,867 Posts
Discussion Starter · #2 ·
Bump


Sent from my iPhone using Tapatalk
 

·
I'm not new
Joined
·
25,743 Posts
I have never torqued the upper gear bolt. Blue lock tite and don't over tighten.

Two part torque for the primary. 65 lbs. then run on stand to 20 mph and hit the brake. Do this 5 times and re-torque to 70
 

·
Registered
Joined
·
2,149 Posts
What I did when I changed top gear is used torque wrench to remove bolt and watched the needle retorqued to that number I think mine was like 45 lbs when it broke loose.
 

·
I'm not new
Joined
·
25,743 Posts
Breaking loose and tightening too are going to be different numbers. That bolt has been in there and gets seated...plus you need to break the lock tite.

If it takes 45 pounds to break loose the original torque spec is likely significantly less than that.
 
1 - 7 of 7 Posts
Top