Ski-Doo Snowmobiles Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
134 Posts
Discussion Starter · #1 ·
Over the last week I installed 96 studs and had to drop the skid a little so the 1" protectors would fit. The problem is that the protector seem loose in the guides of the heat exchangers is this normal or do I have a problems. Thanks in advance. D
 

·
Registered
Joined
·
134 Posts
Discussion Starter · #5 ·
Back to front is O.K it's side to side that is the problem. Anymore suggestions would be great. Thanks all. D
 

·
planes take off against the wind
Joined
·
15,035 Posts
some side to side is ok - if and when they are in use the forces will push them up and forward. You can pinch the ends of the tunnel to hold them some but I would not worry about it.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top