Ski-Doo Snowmobiles Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3,253 Posts
Discussion Starter · #1 ·
I'm adding reverse to my 04 600 HO. I've got the flywheel off and also the 2 screws off the only trigger coil in it. The trigger coilwith all the silicon is loose from the case. All the wires are disconnected from the MPEM and it's out also. I popped the grommet out from the inside of the case but know I can't hardly even see it let alone try to get the trigger coil wire out. I know that I'm putting a sturdy string on the end connector before pulling it though. I'm wondering if you need to pull the carbs and possibly the right carb boot to get to it. What's the best way?
 

·
Registered
Joined
·
9,148 Posts
Pull the carbs, you'll have more room. If it still isn't enough pull the MAG carb boot. I haven't done it any other way. I have my engine out so I had that stuff all removed as I removed my stator. Put the largest electrical connector from the stator through the hole first, then the rest. Good luck.
 
1 - 2 of 2 Posts
Top