Ski-Doo Snowmobiles Forum banner
Cancel

TRA primary clutch brass bushing specs

302 Views 2 Replies 2 Participants Last post by  moresquirt, 
M
Anyone with the work shop manual could you give me the specs on the brass bushings in TRA CLUTCH.
Reply
Save
Like
1 - 3 of 3 Posts
G
Only thing I found in Shop Manual:
Sliding Sheave and spring cover Bushings

Visually inspect coatings on #14&#15(spring cup & sliding half). Replace if worn.
-Grover
See less See more
Reply
Save
Like
M
Thanks again Grover! Everything looked good,its going back on.
Thease Doo clutches are easy to work on and really stand up pretty good compared to the Polaris stuff I am so used to.
Reply
Save
Like
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Ski-Doo Snowmobiles Forum
A forum community dedicated to Ski-doo snowmobile owners and enthusiasts. Come join the discussion about trails, racing, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General Discussion REV Chassis - Performance and Trail Models Sledding - General Discussion REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models MXZ / Legend / Summit / Grand Touring / Formula
Top