Ski-Doo Snowmobiles Forum banner
1 - 11 of 11 Posts

·
Phil in the NEK
Joined
·
985 Posts
looks good!

now a little off topic

I have the same sled lift and just put the wheel kit on it. when I lift the sled up it causes the brackets to bend to the poingt that it will not roll. Did yours do this?
 

·
Registered
Joined
·
222 Posts
Discussion Starter · #7 ·
I wet sanded from 600 up to 2000grit. Then I used Mothers Billet Metal Polish. Take your time and put some elbow grease ino it. This was the first tunnel I have polished, it was not that bad.
Have Fun
 

·
Registered
Joined
·
222 Posts
Discussion Starter · #9 ·
SnoHun said:
looks good!

now a little off topic

I have the same sled lift and just put the wheel kit on it. when I lift the sled up it causes the brackets to bend to the poingt that it will not roll. Did yours do this?
[snapback]257869[/snapback]​
Mine does roll. It does not clear the ground by much but it does clear.
 
1 - 11 of 11 Posts
Top