Ski-Doo Snowmobiles Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
791 Posts
Discussion Starter · #1 ·
Wanna stud the ole ladys REV, have heard theres a special kit needed, if so what is it? anyone have idea's? pictures of kit?
thanks
Mike
 

·
Registered
Joined
·
1,479 Posts
Doo sells this kit and its like $75. Some guys on here will tell you to adjust your pattern to fit the strip openings that are on the sled. I have only used the kit, so I dont know. Im not sure about the peices for the snowflap when doing it without the kit either. Im sure someone here will pipe up thats done it. If you do use the kit, it takes a little time, but its nothing you cant figure out.
 

·
Registered
Joined
·
448 Posts
i have an 03 rev 800 that I put the studs and tunnel protecters in.
it was a project. you have to remove the rear suspension and the seat.
the tunnel protecter kit mounts beside the heat exchanger, and you have to line it up and drill some holes to rivet it in. there are also protecters for the beaver tail.
a bit of a chore compared to the 04 we also have, but not to bad.
plan on a long afternoon to complete, it works extreamly well though, I have 212
in mine and not a scratch under there from a pick.
 
1 - 4 of 4 Posts
Top