Ski-Doo Snowmobiles Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Is it possible to replace stator and or change crank seal and grease mag bearing on a 2001 mxz 700 without removing motor from sled.
 

·
Premium Member
Joined
·
779 Posts
Stator, yes that can be done with the engine in the sled.

If you want to add isoflex grease through a stator bolt hole, that could be accomplished as well.

It will require splitting the bottom end if you want to properly clean out the old grease and replace crank seals.

If you're going that far, you'll want to spin those 20+ year old crank bearings in your hands to see what kind of shape they're in anyhow.
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #3 ·
Thanks pma1123 . Good to know. Are there any videos out there on greasing mag side bearings.
 
1 - 3 of 3 Posts
Top