Ski-Doo Snowmobiles Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I'm looking for information on replacing the stator on my 1997 mach 1. I pulled off the flywheel with a puller but now I need to take off the magnito flywheel. I tried putting a puller on it put afraid to pull to hard. I was wondering if it threaded on the shaft or if I need to pull harder. Please help before all the snow goes away.
 

·
Registered
Joined
·
118 Posts
Mach D gotter. Rap the end of the puller with a hammer while pulling outward with your other hand. I hope your using a puller that has holes in it that match up to the threaded holes for your recoil cup. Snug that baby up to where you think the 3 bolts are going to break, well a hair before that but tighten the puller and hitter.
Ebay just had a couple stators for your sled advertised. You can also have it rewound for around $160.00 with a 1 year warranty. I've had many redone.
 

·
Registered
Joined
·
6,219 Posts
Then when you get a new stator on get a set of MSD coils from ModmachZ and you will never have a stator go again.
 
1 - 4 of 4 Posts
Top