Ski-Doo Snowmobiles Forum banner
1 - 15 of 15 Posts

·
Registered
Joined
·
1,559 Posts
My version of the iron dog 1200...

Tire Wheel Vehicle Automotive tire Automotive lighting


Tire Wheel Vehicle Automotive tire Motorcycle


Automotive tire Hood Automotive design Motor vehicle Automotive exterior


2016 MXZX MOD list ......

- CA PRO Razors Skis, sunburst loops, running modified RSI scratchers on spindles
- Mainway Solutions A-arm bushings

- GnR upper-lower braces
- BRP extreme skid plate with rivnut fastners
- Pro 40 XRS shocks with RS springs and custom retainer and valve job
- RipSaw II 1.5 track
- 45 bottom gear (stock was 43)
- GnR billet axle spacers and BRP 4th wheel kit
- Extra suspension strap added
- 270/271 torsions with stiffer center shock tender spring and valve job
- Dupont Slides
- Iron Dog Rail stiffeners and bump stops added
- RaceWrex QRS tower brace with RaceWrex engine snubber
- Primary PB80 & QRS custom clutching, GATES Carbon belt, my belt guard mod
- QRS shimmed 3mm
- BRP goggle bag for belt guard
- BRP Sunburst floorboard braces
- Overflow tube extension for coolant overflow
- Battery tender pigtails mounted
- Linq 1+1 seat mounts
- Linq small bag mounted
- GnR ISOvibe with RAM tab mount for GPS
- 12 volt socket mounted on dash and 12v mounted in glove box
- BRP glove box liner added
- BRP flare extensions for handguards
- All under hood foam removed
- Custom venting and additional heat protection added
- Insulated air box, wrapped exhaust
- BRP folding mirrors

- XRS low windsheild
- FreeRide guage cluster

- HD rear bumper
 

Attachments

·
Registered
Joined
·
1,559 Posts
Can you measure the width of the panels on the sled from the very edge to the other edge? I cant believe how wide this sled looks
It's roughly 37 inches flare edge to flare edge. I don't mind the flares as they are going to make a perfect area for venting heat.

Tire Automotive tire Automotive lighting Motorcycle Hood
 

Attachments

·
Registered
Joined
·
1,559 Posts
Discussion Starter · #7 ·
very nicely done

what are you running for shocks in the rear skid

we run fox zero pros set-up by ian at monster performance

I have had a 129 for 4 seasons now and love it
XRS Pro 40's out back
 

·
Premium Member
Joined
·
8,606 Posts
Hey sleddingfarmer---I am considering drilling the panels in my 2014 1200x. After you drill the holes would you recommend putting screening in behind or not ??

I ride 95% trails.

Also--Thanks for the link for the template.

Don~
 

·
Registered
Joined
·
6,298 Posts
Hey sleddingfarmer---I am considering drilling the panels in my 2014 1200x. After you drill the holes would you recommend putting screening in behind or not ??

I ride 95% trails.

Also--Thanks for the link for the template.

Don~
Oops I just saw this. I wouldn't worry about any screen if you're just drilling on the back side of the panels near your knees like I did. I've been in deep powder, buried up to the headlight, stuck repeatedly and never had any issue with snow getting in. For trail riding, you'll be fine

Sent from my XT1254 using Tapatalk
 
1 - 15 of 15 Posts
Top