Ski-Doo Snowmobiles Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
209 Posts
Discussion Starter · #1 ·
I installed a Cudney clutch kit and reeds and spacers. This combo works great with noticable diference in sled performance, but I was concened because I was only reving to 7700-7800, now all of a sudden 400 miles later it will rev out to 8200 ? air temp about the same, nothing changed ? any input would be appreciated.
 

·
Registered
Joined
·
433 Posts
Could be the secondary is binding. Did you take it apart and make sure everything is ok and its clean? I would start there if nothing else has changed.
 

·
Registered
Joined
·
21 Posts
you should install an adjustable pin kit in you TRA III primary and play around until you get the proper RPM you are looking for!!
 

·
Registered
Joined
·
990 Posts
BiggMac said:
you should install an adjustable pin kit in you TRA III primary and play around until you get the proper RPM you are looking for!!
[snapback]259478[/snapback]​
He says he has a Cudney kit so he should already have adjustable pins.
 
1 - 6 of 6 Posts
Top