Ski-Doo Snowmobiles Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I have an 03 rev with a beavertail. The other day i was jumping my sled in low snow conditions and landed hard on the rear of the sled bending 2 of the three 180mm rear axle wheels. since my sled is the bond with the black idlers under the chrome covers i tried to order 2 basic black idlers one for outside the suspension rail on the left side and one for in-between the suspension rails replacing the 2 that i bent. however when the wheels arrived they were both the narrower style designed for inside the suspension rails. I am just wondereing if these thinner wheels will hold up as well as the older thicker style and i should go ahead and use them or try to locate another wheel. I have a snowmobile rally in 5 days and ski doo says ordering another part could take 5-10 days depending on the weather.
 
1 - 1 of 1 Posts
Top