Ski-Doo Snowmobiles Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
54 Posts
Discussion Starter · #1 ·
Installing a replacement speedo for my fogged up one on my MXZ 800 HO Gade. I did not have the instructions and just plugged in the unit. It flashed "pause" for a while and then scrolled through 0-0,9-9,10-9 and did not work.
Later I was able to get my hand on the instructions and I was supposed to select 10-9 when it scrolled by. This is for the 10 tooth drivers. The only problem is the speedo now comes up on 9-9 and I can not change it.
Does anyone know if this can be changed or do I have to scrap the speedo and buy a new one. Sure wish I would of had the instructions before I plugged it in.
 

·
Registered
Joined
·
54 Posts
Discussion Starter · #3 ·
sledcrazymxz said:
What about unpluging it then pluging it back in maybe it will re-set its self allowing you to chose 10-9 , just a thought
[snapback]295685[/snapback]​
No tried that but thanks for the idea
 
1 - 4 of 4 Posts
Top