Ski-Doo Snowmobiles Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
37 Posts
Discussion Starter · #1 ·
I have removed the clutch and now I am trying to remove the levers to replace the pins. I have removed the two 10mm bolts but the lever doesn't want to come out. Is there something else I need to do for the levers to come out? Do I just need to find something to get under it and pry it out?

Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
37 Posts
Discussion Starter · #2 ·
Actually it's the clutch arms that I can't get out.

Sent from my iPhone using Tapatalk
 

·
Premium Member
Joined
·
27,910 Posts
You got it right with prying. It's not going to require crazy amount of leverage, but it can take some force to get them out.
 

·
Metalhead
Joined
·
9,088 Posts
Ugh….they can be a somb3otch to pull out. Ive done only like 2 clutches in my whole career on TRA7 where the levers easily come out. Ive had to pry them out. Make sure the axle is centered in the aluminum bosses and then try to pry them out. They can be a dose….

On my 2013 primary, I rebuilt it and as far as the levers went, I thought I was going to bust the dam levers, I said "fkkit" on them…hahaha
 
1 - 4 of 4 Posts
Top