Ski-Doo Snowmobiles Forum banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
3,124 Posts
Discussion Starter · #1 ·
Hi,
Me again fiddling with the new sled ,anyway I'm trying to get the reat spring cams adjusted a bit stiffer( less sag when I sit on it) I followed the manual the picture wasn't the same as my 500 ss adr mxz I turned the right one counter clockwise and the left clockwise ,I noticed that they are at different settings and It said that this may be normal but I think I may have turned one an extra notch
is ther a way to set them even so I can check my work ? if they are at different settings will this spell dizaster? Help will be appreaciated
Thank you
Charlie in VT
 

·
Doo Pilot
Joined
·
1,962 Posts
Charlie,turn them to the same cam spot on each side.If you went further than you wanted to just keep turning until you get it as the same spot as the other side.
If you look on the clutch cover it will give you some Ideas for setup !
Mind you these are suggestions not the rules
Rich
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top