Ski-Doo Snowmobiles Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
849 Posts
Discussion Starter · #1 ·
I was checking my plugs the other day and they seemed to have a good tan color but they where a little wet. I have dropped the main jets to 370 and dropped the needle like suggested in the optimizing 600ho post.

The wetness on the plugs looked like gas not oil?

Is there and adjustment i should make?

by the way it is an 03 600ho rev

Thanks for any help Matt
 

·
Registered
Joined
·
483 Posts
I think you should be just fine, if the plugs are a tan or carboard color just leave it alone, the best way to read a plug is after a full throttle run you chop power midway do not let the sled sit and idle as it will alter the reading so full power then shut it down read plugs, don't do this a lot becuase you put fuel in the pipe
, the wet you see is probably from idiling and is perfectly normal
 
1 - 3 of 3 Posts
Top