Ski-Doo Snowmobiles Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1,481 Posts
Discussion Starter · #1 ·
i got a cudney clutch kit on a 800ho geared down 1 tooth on top, put 1/4 reed spacerss and tpi valves on and has a mbrp can on and it over revs, at 8100rpm
i was wondering how i could get it back down to peak rpm?
 

·
Samsquamch
Joined
·
1,652 Posts
Drop Bill a line,he'll point you in the right direction!
 

·
Registered
Joined
·
2,002 Posts
Does it over rev all the way thru, or just at the top end? I'm thinking if it's over all the way thru, add a bit more weight, if it's just on top, gear back up a notch? I'm no clutch guru though...
 

·
Registered
Joined
·
351 Posts
Revolution said:
i got a cudney clutch kit on a 800ho geared down 1 tooth on top, put 1/4 reed spacerss and tpi valves on and has a mbrp can on and it over revs, at 8100rpm
i was wondering how i could get it back down to peak rpm?
[snapback]279676[/snapback]​
Make sure your clickers are on 3 and
Add some weight to the pins to drop RPM
 
1 - 5 of 5 Posts
Top