OEM TUNNEL PROTECTION QUESTION

503 Views 5 Replies 5 Participants Last post by jpr-racing, Oct 4, 2006

SACANDAGA

Discussion Starter · Oct 4, 2006

I bought the OEM tunnel protection (06 Mach Z) and it has a large tappered area at one end. Does this end with the tappered area go up front? I used to cut a small angle at the rear as well, does everyone still do this? I plan on running 192 1.175 Woody trail studs.

Thanks in advance.

Save

1 - 6 of 6 Posts

saint1000

· #2 · Oct 4, 2006

ttaper goes to the front

Save

SACANDAGA

Discussion Starter · #3 · Oct 4, 2006

saint1000 said:
ttaper goes to the front

Great! Thanks for the reply

See less See more

Save

rodder

· #4 · Oct 4, 2006

SACANDAGA said:
I bought the OEM tunnel protection (06 Mach Z) and it has a large tappered area at one end. Does this end with the tappered area go up front? I used to cut a small angle at the rear as well, does everyone still do this? I plan on running 192 1.175 Woody trail studs.

Thanks in advance.

Make sure the ones you have are the real tall ones, I ran the aftermarket ones that are taller than the DOO ones and still got some scrapes!!!Only on hard landings , and got a few up front from LAKE pulls. But those scratches are gone after DOO warrantied my tunell!!!!

See less See more

Save

crazy northern rider

· #5 · Oct 4, 2006

and make the angle at the back, you woldnt want you track getting caught on them on a hard landing.

Mitch

Save

jpr-racing

· #6 · Oct 4, 2006

if you have chance,take a look under a mxz-xrs that came with a ice ripper.the protecters are wide and piece of art.they will be sell as accs.

See less See more

Save

1 - 6 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month