Ski-Doo Snowmobiles Forum banner
1 - 11 of 11 Posts

·
Mod'n is my thing
Joined
·
6,288 Posts
Discussion Starter · #1 ·
The main connector that comes from the main body harness up to the handle bar wire bundle is the pinout I'm looking for.

All the wires on the ptek are new colors and I want to double check my setup before I fire it up.

thanks, Chuck
 

·
Registered
Joined
·
700 Posts
Hey there Chuck, I have the wiring diagrams from my manual for the power tek 800 with and without electric start, but can't get a good enough picture for ya.
 

·
Mod'n is my thing
Joined
·
6,288 Posts
Discussion Starter · #4 ·
If you could just look at the handlebar connector and tell me the numbers on it and what each wire goes to.

There are 13 pins on the connector but only about 10 of them are used.
example> Pin 1 = ground
 

·
Registered
Joined
·
4 Posts
Need og the wiring diagrams ?

Have the -05 workshop manual scanned to PDF aswell as the wiring diagrams in full size, this is fore my own purpose and will not sell but can chare the specific diagram if you want.

Regards.
Mike from Sweden
)
 

·
Mod'n is my thing
Joined
·
6,288 Posts

·
Doo Pilot
Joined
·
1,895 Posts
Are you still in need of a diagram ?
I can send it as attachents to email
Rich
 

·
Doo Pilot
Joined
·
1,895 Posts
Sent
Let me know if you recvd it
Rich
 
1 - 11 of 11 Posts
Top