Ski-Doo Snowmobiles Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
921 Posts
Discussion Starter · #1 ·
I will send all your risers tomorrow morning. Here is a picture of where you move the throttle cable to, I just went out tonight and took a pic to show you. Also take the black console off, only 4 small bolts and gives you much more room to tighten
the lower bolts. Cheers, Rene.
 

Attachments

·
Registered
Joined
·
196 Posts
Jeez rene that 600 looks like its getting awfuly dirty. You better get out a rag and start shining her up for the dootalk ride.
 

·
Registered
Joined
·
52 Posts
Good stuff Rene, i also recomend using some blue loctite ( the removable kind ) on the threads, mainly as a lubricant and to help seal out some moisture to help stop any corrosion. Just dont forget to check your cable length, after the install, turn the ski's to the stops left and right to make sure the sled does not rev up by itself, if it does, there is somthing wrong, check the routing again.
 

·
Ski-doo's poster boy
Joined
·
2,128 Posts
I Dare Ya Rene! said:
Yah, I took the pic in the dark last night and noticed how dirty it looked. I better get the Vim out!
[snapback]690019[/snapback]​
What the heck is a Vim????????
 
1 - 6 of 6 Posts
Top