Ski-Doo Snowmobiles Forum banner

I Cant Figure this out...

589 Views 6 Replies 4 Participants Last post by  Milley_LabradorRider
Questions are ......

What goes onto? #1

What goes onto? #2

for # 3 should there be a outlet like there is on my 440, if not what should i do with the tubes that goes there?

Thanks You

Attachments

See less See more
1 - 7 of 7 Posts
YK RACER said:
Questions are ......

What goes onto? #1

What goes onto? #2

for # 3 should there be a outlet like there is on my 440, if not what should i do with the tubes that goes there?

Thanks You
[snapback]914538[/snapback]​
1: will be the impulse line to run your fuel pump.

2: goes to the small oil bottle that feeds the water pump shaft (picture of oil bottle)

3: There is no fitting there don't worry about it!!!! The line that went there on your 440 motor will NOW get hooked to #1 in your picture

Attachments

See less See more
1 and 3 are both pulse lines for the fuel pump. 1 is where the 440 line went and 3 is where the consumer models use. Wherever it went on the 440 engine, plug it in there.
2 is for the water pump oil resevoir.
awsome , the #1 pulse line outlet the hose that goes onto it is black right?
YK RACER said:
awsome , the #1 pulse line outlet the hose that goes onto it is black right?
[snapback]914989[/snapback]​
That is correct
just making sure that you are aware that the center of the base is supposed to be filled with oil b4 putting the engine in the sled. tip the engine foward and remove the plate below #2. fill it with oil then install the plate again. this ensures that the water pump gets lube.
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top