Ski-Doo Snowmobiles Forum banner

How to change secondary spring??

2K views 5 replies 6 participants last post by  Trail Cruiser 
#1 ·
Can anyone point me in the right direction as to change this spring please and thanks?
 
#2 ·
special tool required, or you can make your own, that is if you are asking about your 2020

i made my own with a threaded rod and rubber plug

buy 18 inch long by either .375 or .50 threaded rod and a couple nuts/washers that fit rod

on harbor freight look up "sanding drum kit" to use as rubber plug

drill out plug to accept rod, may need to size outside diameter of plug to fit into QRS

need to remove QRS from machine,

place a nut on both sides of plug and insert into qrs and tighten nuts to expand plug

then need to compress helix/spring and remove bolts from backside of helix/sheave

little more involved but short version
 
  • Like
Reactions: Gade17
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top