Ski-Doo Snowmobiles Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
235 Posts
Discussion Starter · #1 ·
Hey guys, i just changed the steering support, part number 41 in this diagram. It had a light hairlin crack in it. http://216.37.204.206/ingles/Skidoo_oem/Sk...e=13&A=553&B=34

Well we put it back together, and the bars weren't turning very easy, so we looked it over and loosened bolt #4 i believe and that helped a lot, but i'm wondering how tight this bolt needs to be, does anyone know the tourque spec, or can i just loosen it until the sled steers easy again?
Thanks TJ
 

·
Registered
Joined
·
1,628 Posts
Do you have number 3 in? It looks like a bushing to allow you to tighten it up without binding. I would make sure you are not missing any parts and that nothing is bent. Good luck
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top