Ski-Doo Snowmobiles Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Suddenly began switching between forward and reverse on its own at idle.

Would not stay in either. Luckily managed to get it to stay in fwd momentarily and give it gas and keep the revs up so got off the trail.

(sometimes giving it gas would simply switch it in opposite direction)

As soon as I would slow to idle it would begin again.

I have searched for hours and it seems to be reverse switch- but can find no help on disassembly or cleaning of switch. (then to add dielectric grease?)

Any help on removal, cleaning and disassembly of unit could really make this attempt at repair easier.

Thanks in advance!
 

·
Registered
Joined
·
305 Posts
You have to remove the brake assembly on handle bar (2 screws) then on the back of the block there is 4 Phillips screws then it should come apart then each switch should be held in with a screw, after unscrew they pop out then disassemble and add dialect grease.

Sent from my SM-G930V using Tapatalk
 

·
Registered
Joined
·
20 Posts
The exact same thing started happening to me today. It would start then go into revierse, then start again and would repeat until i would shut the sled off. it eventually ran again enough to get it into the garage between the constant forward and back cycle.

How did you make out? Was that the problem?
 
1 - 3 of 3 Posts
Top