Ski-Doo Snowmobiles Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2,268 Posts
The silver trim ring around it. Has to be accessed from the back side.
Remove the 4 screws securing the console, 2 in front underneath the light where the hood rests. And 2 on the sides of the handle bars toward the clear wind shrouds.
Then pop out the half moon plastic piece at the base of the handlebars if you have the post forward mod.
The console will be loose, but you have to reach underneath and unplug the harness to remove it.
Then in the back side of the gauge you'll see where there's a locking tab on the trim ring. Push and twist and out comes the gauge.
 

·
Registered
Joined
·
606 Posts
I have done it without removing any other parts, as said above unplug wiring then push the lock tab with a small flat blade driver or a pick. then it should rotate and release from console.
 
1 - 3 of 3 Posts
Top