Ski-Doo Snowmobiles Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
278 Posts
Discussion Starter · #1 ·
http://www.alltradetools.com/index.html/sc.../product_id/611

$20bucks at canadian tire I bought 3 M8x40mm and 3 M8x60mm 8.8 Bolts for added strength, I have heard of people breaking the bolts often. Used the 60mm ones, always good to have spares though.

This puller will come out on one end and in on the other to catch the case in the correct spot to both loosen and tighten the nut if you use it with two bolts only (to allow access to the nut). When I was cranking the flywheel off, I stuck a long screwdriver between two of the bolts and let it go up against my pipe to lock.

This worked for me, may not work for others, but worked better IMO than "the rope trick" or an impact gun. I have used a factory puller, obviously its the best, but I couldn't get one at the time and have no idea how much it is. Disclaimer! use at your own risk!!!
 
1 - 1 of 1 Posts
Top