Ski-Doo Snowmobiles Forum banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
3,023 Posts
Discussion Starter · #1 ·
Hi,
Decided to be on the safe side and put the needle back to stock with my kids sled with new Vforce reeds plugs read slightly lean so I'm going to be safe . How do you put the needle to stock on a 03 600 Ho?
thank You
Charlie
 

·
Registered
Joined
·
910 Posts
charlie said:
Hi,
Decided to be on the safe side and put the needle back to stock with my kids sled with new Vforce reeds plugs read slightly lean so I'm going to be safe . How do you put the needle to stock on a 03 600 Ho?
thank You
Charlie
[snapback]696334[/snapback]​
The only needle adjustment on the 600h.o. that I know of is moving the shim from under the needle to the top of the needle. So to put it back to stock -place the white shim underneath the e clip on the needle and reinstall.
(this is done by removing the two screws on the top of the carb and opening the throttle, loosen the allen srew slightly and move the retainer over, pull the needle out the top.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top