Ski-Doo Snowmobiles Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
45 Posts
Discussion Starter · #1 ·
Ok guys might be a bit winded and old but the search wasn’t helping maybe my “key words” aren’t good enough so bear with me. I’ve got an old1995 670 rave fchassis with a running motor and broken tunnel complete, And 1997 s chassis 670rave complete but with no motor. I was hoping to just swap them out but noticed the plug connectors are different (F is square and S has a round) coming off the engine doo I need to do a complete harness swap or can they be cut and hard wired...all the wiring is in the1997 670...it blew the crank and was just unplugged and pulled out so it’s all there just different plug in from the stator
 

·
Registered
Joined
·
559 Posts
If you can verify the wire colors are the same and same number of wires for each connector you can make your own Deutsch connectors (an example) then plug/play.
 

·
Registered
Joined
·
45 Posts
Discussion Starter · #3 ·
Ok I’ll take a better look at it tonight and see what’s what, last one I did was an hour and 5 beer plug and play this one just seems a bit different and don’t want to do a whole harness swap out if not needed
 

·
Registered
Joined
·
3,378 Posts
1 - 5 of 5 Posts
Top