Easiest way to get drivers off

344 Views 5 Replies 6 Participants Last post by bransan, Oct 5, 2006

mxzrev8001

Discussion Starter · Oct 4, 2006

what is the easiest way to get the end driver off without damaging it. im putting on two new middle drivers and i was just wondering if anyone has a good way of getting them off the shaft. Thanks Ben

Save

1 - 6 of 6 Posts

boondocker99

· #2 · Oct 4, 2006

Shop press if you know what you are doing or your dealer...

Save

MACH D

· #3 · Oct 4, 2006

They need to get pressed off. Normally the plates for the press work just fine.

Save

Shaneo13

· #4 · Oct 4, 2006

Bring them to a machine shop and have them measure it out and put the new ones back to where the old ones were... I just do my own, so Its pretty ez tho. Are they extrovert drivers?

Save

05GSXRIDER

· #5 · Oct 4, 2006

normally once you press them off you don't want to press them back on usually get new ones if you have to take them off.

Save

bransan

· #6 · Oct 5, 2006

mxzrev8001 said:
what is the easiest way to get the end driver off without damaging it. im putting on two new middle drivers and i was just wondering if anyone has a good way of getting them off the shaft. Thanks Ben

BRP reccomends replacing any drivers once they've been removed. There is a nice spec. in the service manual that should give your local machine shop plenty of info to mount the new drivers in the proper location. I have removed one outer driver and reinstalled it. 3000 mi later everything still looks good. Make sure the arrows are lined up!

See less See more

Save

1 - 6 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month