Ski-Doo Snowmobiles Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
75 Posts
Discussion Starter · #1 ·
I was looking for the wires to hook up my new electric shield, and I unhooked the rear wire group on the MPEM so the wire was closer to work on.Thinking that I'd better fire it up and check the voltage first, I cranked it over once and remembered the plug. After plugging it back in it won't fire. The lights don't flicker when I pull it or nothing on the gauges either.Did I fry it or is there a relay or fuse to check ?
 

·
Registered
Joined
·
9,148 Posts
You didn't have your shield cord grounded did you? If you left one end dangling its very possible it could of touched the frame. That will short the regulator output to ground causing it to shutdown. Put everything back as it was and go from there.
 

·
Registered
Joined
·
2,383 Posts
Yep got it runnin' tonite and did all the testin. I quess I was getting parinoid Thanx!!!
i have been having the same problem but havent had the chance to figure it out. what was ur issue
 
1 - 6 of 6 Posts
Top