cutting race heads for trail use

346 Views 3 Replies 3 Participants Last post by dantrin2000, Sep 29, 2006

440mod

Discussion Starter · Sep 29, 2006

I have a 2004 rev 440 and i am getting a machine shop to cut my heads (its alot cheaper). What i wanted to know was the correct compression ratio for trail on the 04's. Also what is a good gasket to run? anddd i can run 87 or not? i hear one guy say yes and another say no.

Save

1 - 4 of 4 Posts

Stevie_Wonder

· #2 · Sep 29, 2006

Send the heads to RadChad here on the fourm. He done my heads from my 04. Only charges 100 bucks and does a great job. I wouldnt send them to nay old machine shop, if they fool em up your out a few hundred bucks

Save

440mod

Discussion Starter · #3 · Sep 29, 2006

Stevie_Wonder said:
Send the heads to RadChad here on the fourm. He done my heads from my 04. Only charges 100 bucks and does a great job. I wouldnt send them to nay old machine shop, if they fool em up your out a few hundred bucks

[snapback]914807[/snapback]

the guy i am sending them to raced sno cross for years and i have heard from a few other guys it worked out great. But i know what you are saying.....hope this guy does a good job.

Save

dantrin2000

· #4 · Sep 29, 2006

I think there was something on here about 22 ccs.

440mod said:
Stevie_Wonder said:

Send the heads to RadChad here on the fourm. He done my heads from my 04. Only charges 100 bucks and does a great job. I wouldnt send them to nay old machine shop, if they fool em up your out a few hundred bucks

[snapback]914807[/snapback]

Click to expand...

the guy i am sending them to raced sno cross for years and i have heard from a few other guys it worked out great. But i know what you are saying.....hope this guy does a good job.

[snapback]914824[/snapback]

Save

1 - 4 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month