Ski-Doo Snowmobiles Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi Has anyone had a problem with the little alignment pins on the bearings in the crank case. My 03 800 has about 1500 miles on it and one of the pins bent and broke a piece of the bearing off causing the crank shaft to push the clutch side seal out and spit oil all over the clutch and belt. This and about $2000.00 later I hope it won't happen again. Any ideas? Thanks ken800rev
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top