Ski-Doo Snowmobiles Forum banner
Cancel

clutch guard/oil caddies

311 Views 1 Reply 2 Participants Last post by  Lakelandsledder, 
M
I'm looking at installing either the powermadd or choko clutch guard tool box. Will either of these work with the raised vents in the clutch guard? Also if I install the single oil caddy on the clutch side is there enough room to remove/install the belt? Sled is a 01 600 dlx. THANKS! Mike
Reply
Save
Like
1 - 2 of 2 Posts
Lakelandsledder
You should be ok with the tool caddy, but I don't believe the oil caddy will fit.
Reply
Save
Like
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Ski-Doo Snowmobiles Forum
A forum community dedicated to Ski-doo snowmobile owners and enthusiasts. Come join the discussion about trails, racing, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General Discussion REV Chassis - Performance and Trail Models Sledding - General Discussion REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models MXZ / Legend / Summit / Grand Touring / Formula
Top