Ski-Doo Snowmobiles Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
115 Posts
Discussion Starter · #1 ·
Just wondering where my clickers should be? they are set at 5 right now, machines revs solidly at 8000. radared at 96.5 on the week end thought that it should have a little more than that. I also noticed that it only has a 24 tooth top gear i don't beleive that that is stock/should it be changed? Not a big problem right as i beleive that somehow i put the motor out of alignment as i chewwed up 3 belt's to get of the lake after the radar run. sorry for the run on.
 

·
Registered
Joined
·
237 Posts
my 98 runs 8200 RPM WOT through out the shift pattern , 8400 is supposed to be peak but Ski Doo recommendes 200 RPM under for the best performance , got this out of the race book , if you went through 3 belts better get it lined up you most likley will gain a lot of performance , I have run the same belt for two years and it is still like new & setting above the driven pulley about 1/16 inch. good luck
almost forgot , my clicker is set on four
 

·
Registered
Joined
·
115 Posts
Discussion Starter · #3 ·
which way do i move my clicker's to gain rpm.i hope not up as it is already on 5. should i have more speed or is that about it?
 
1 - 3 of 3 Posts
Top