Ski-Doo Snowmobiles Forum banner

Chain Case Oil Weight

18K views 9 replies 8 participants last post by  mschmidty  
#1 ·
Guys:

Not a question, but a piece of info I got today.

I was looking at the XPS Chain Case Oil and found it annoying that Ski-doo won't publish the weight of that oil on the bottle.

Further, their product safety data sheet was not coming up online, so I used the contact button and asked.

Amazingly, they responded within an hour with an actual answer (and link to the Ski-doo oil...of course).

In an archived thread (which I would have preferred to respond to, but couldn't) I found a bunch of guys saying they use Synthetic 75w90 of various brands and even some saying they use ATF.

According to BRP today, the oil is actually 75w140 (Spec: GL-5, which most gear oils are).

So 75w90 might be a little thin when it warms up...

Just thought I'd forward this to the group.

Happy summerizing! :-(
 
#3 · (Edited by Moderator)
Guys have been using ATF for years in Doos
[emoji1688][emoji1688][emoji1688][emoji1688][emoji1688]

Some of us have found better alternatives
bd3c10c81b46bd9c363625271be7b7d9.jpg
Ha ha.. that is a pretty light weight or density lube you have in that partial chaincase!.... Not much to wipe up when you pull the partial side cover. Just wish they didn't cost so much!

Yep lots of ATF used in transfer cases with chain link drives.. And even Chrysler used it in their 4 speeds of old.
 
#4 ·
I sure am glad that BRP has shown an alternative to the chaincase oil. I buy the XPS in 10L so I'm good for a while.

2020 manual now lists 75W140 gear oil - Sledding - General ...
Apr 18, 2019 - 15 posts - ‎13 authors
The new 2020 manual now lists 75W140 as an alternative to the ski doo chaincase oil, now if they can just come out with a 500 ml bottle for the ...
 
#7 ·
They say you can use 75w-140, but I dont think there XPS synthetic is 75w-140. They state in the accessory catalog that the XPS chaincase oil is not for use in Expedition and Skandic transmissions that require 75w-140?
Now that is a question worth asking BRP by email. It pays to avoid making the assumption that the info in Shop Manuals or Operator's Guides are absolutes. I have found too many errors over the years to make that assumption. Heck I have a document that I continue building to keep track of them so I don't forget which ones they are and in what documents.