Ski-Doo Snowmobiles Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
522 Posts
Discussion Starter · #1 ·
I have some ULTRA skis that i am geting rid of for C&A advantage 6in wide skis.. do i need new carbides or will the ones from my ULTRA III skis fit??
 

·
FAQ man
Joined
·
3,848 Posts
Ok, the bars on my C&A Razors have the following measurements, hope this helps...

-The bars are 17" long overall.
-There are 4 mounting studs. Let's call the front stud #1 and the back stud #4.
-The distance between #1 and #2 is 4"
-The distance between #2 and #3 is 6 3/4"
-The distance between #3 and #4 is 4 1/2"

Make sense??

Jerry C.
 

·
Registered
Joined
·
1,242 Posts
If I remember correctly, one of the skis has a little hole up front that the front of the carbide hooks into. The other one is straight. So you may have to cut that hole in the ski or cut the front hook off of the carbide. The bolt patern WILL fitt.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top