Ski-Doo Snowmobiles Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
85 Posts
Discussion Starter · #1 ·
This is my first post here but have been a lurker for a while. Right now I'm going through my entire 04 mxz gade and freshening it all up for the upcoming season. So my question is, is the rotor supposed to be able to float right or left an 1/8 or so after it is all installed correctly. What is happening is the collar on the shaft with the brown oring in it between upper bearing and rotor is allowing oil to sling out on the outside edge of rotor.

Thanks Tyler.
 

·
Directional Driller
Joined
·
974 Posts
replace the seals in your case and the key stock that locks the rotor to the shaft. It'll take the slop out but not completely. You should be in good shape from there.
 
1 - 2 of 2 Posts
Top