Ski-Doo Snowmobiles Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
872 Posts
Discussion Starter · #1 ·
i was just wondering if anyone has bored out this sled.... i am looking to bore it out but i cant get the numbers from rk tek to do so.... all i would need is the bore to do so... bcz i have a machine shop right downt the street and it is only 65 dollars per cylinder to do so... i figured that i would ask this fourm because no on in the performance form is helping..

or i am looking for people to tell me what they have bored their sleds out to.... so i can figure it out how large to bore these...
 

·
Registered
Joined
·
45,484 Posts
Well I donno if this will help, but I just bought my pistons and such and the machinest bored them to spec. But that was just a bit over the stock size. I guess that you should prolly do the same, that way the machinest could match your pistons to jugs. Hope this helps.
 

·
Registered
Joined
·
872 Posts
Discussion Starter · #4 ·
TTT, i was told by cudney racing that i could put a 80mm piston in there and bore it out to make it about a 660 or so.... anyone with this experiance
 
1 - 5 of 5 Posts
Top