[benz88]

Well a few years ago one of the front corners was smashed on my Safari, my dad had screwed in some mesh and bondo'd the corner and belly pan smooth when it was his.Now i took a jump and the junk fell out.Whats a good way to repair this busted belly pan?keep in mind its Plastic otherwise i would make my own corner with some metal and weld it in.Im thinking Fiberglassing it might not hold and get damaged easy

 

[T'NT340Rider]

SEM Problem Plastic, its the strongest material I have worked with, and works out nice too. when done, just apply a light skim coat of your favorite body filler, sand, prime, paint, and its done.

http://www.levineautoparts.com/semprobplasr.html

 

[SEAKtundra]

I once took a piece of a 5 gallon bucket and cut it to fit then riveted it in place on an old SRV. Very slippery an lots of colors available. FWIW

Mike

 

[benz88]

SEM Problem Plastic, its the strongest material I have worked with, and works out nice too. when done, just apply a light skim coat of your favorite body filler, sand, prime, paint, and its done.

http://www.levineautoparts.com/semprobplasr.html

[snapback]704119[/snapback]​

so apply that over the mesh like i would fibreglass than a light skim coat of filler after?

 

[T'NT340Rider]

yep, but you really dont need the mesh, if you dont have to use it.

 

[benz88]

Thanks, ill do this in the spring.

 

[snow_stuff420]

I once took a piece of a 5 gallon bucket and cut it to fit then riveted it in place on an old SRV. Very slippery an lots of colors available. FWIW

Mike

[snapback]704134[/snapback]​

you have a 2006 tundra? what is it like