Ski-Doo Snowmobiles Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
4,990 Posts
Discussion Starter · #1 ·
Trying to help out a member in the MXZ old iron forum.

He is installing his DS and has #11 and #3 inside the bulkhead. I believe #3 should be outside the bulkhead under the plastic cover #12. Been 8 to 10 years since I did one like this. Searched the site for an hour and can't find a definitive answer. Can you guys help us out? Thx.

Font Rectangle Parallel Slope Number
 

·
Registered
2005 gtx 800 limited
Joined
·
9 Posts
Unfortunately I think the damage is done. Those holes are what aligns the driveshaft on that side and being wore so badly it's unlikely the shaft will run true and I would think it will probably cause a vibration and premature failure of bearings or other parts. I would also be worried about it working the nuts loose if it does have a vibration.
I'm sure that it can be fixed with some effort but I would be leary of just putting it back together properly in that state myself.
 
1 - 4 of 4 Posts
Top