Ski-Doo Snowmobiles Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
278 Posts
Discussion Starter · #1 ·
I have a 600HO setup in my 05 mod roller, I am going to try to use the 05 mod taperbore carbs/kickass filters with this setup. Aaen pipe, custom can mod clutches with 412 ramps. Running the stock 600HO mpem.

Anyone played with these carbs on a 600HO or a mod with pump gas? Any suggestions on where to start? I have the 0 tubes installed, but have left the pilot jets alone, and have some 370 mains. Any other suggestions or pointers?

Jordan
 

·
Registered
Joined
·
1,911 Posts
With the taper bores being similar size to stock bore 600 carbs(40mm) i would start with the stock 600 jets,compensate for the aaen pipe(up one or two sizes) and im not sure about the filters(maybe another two sizes) total 4 sizes larger than the stock main jet on a carbed 600 and that all depends where your venting the carbs to,either into the filters or just under the carbs.
 
1 - 4 of 4 Posts
Top