Ski-Doo Snowmobiles Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
45 Posts
Discussion Starter · #1 ·


I'm going to change my 1980 377 engine from points/condenser to cdi
Can someone tell me the procedure to change this.
I'm going to pickup the parts today, & hopefully do this weekend.

Thanks again

JP
 

·
Registered
Joined
·
4,108 Posts
Check for keyway position and tickness,i dont remember if they were different,but im quite sure.You need also a different flywheel.
 

·
Registered
Joined
·
45 Posts
Discussion Starter · #4 ·
Did the change over.
vey easy (even for me!)
Justed removed flywheel, stator plate, & coils, replace stator plate with cdi type,
install 1 coil (modify where old coils were located) to accept 1 coil, & install power pack on air box.
Started 1st pull!
I'll get to test it later this week, Hopefully the timing is right.

JP
 

·
Registered
Joined
·
45 Posts
Discussion Starter · #5 ·
Ok, Had a chance to take it for a spin, no power!
I'm going to adjust the timing. I don't have a timing light. So where should I start?
Also The key doesn't work, does someone know how to wire in the key, & kill switch?

Cheers
JP
 
1 - 6 of 6 Posts
Top