Ski-Doo Snowmobiles Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
First of all, am I in the appropriate forum for such and old machine?
Its a 1985 Tundra.
My question relates to drive cog alignment. The track is rubbing on the left side of the tunnel right at the drive axle / shaft and I noticed that the cogs are right at the left hand edge of the holes in the track, preventing me from shifting the track back into the center where it belongs. Are the cogs supposed to float on the hex shaped drive shaft and if not' what would cause them to shift to the left?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top