Ski-Doo Snowmobiles Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
259 Posts
Discussion Starter · #1 ·
I have the 25mm set screws in 3.8 grams with the 12.4 gram pins for a total of 16.2 and on clicker 2 it will still hit 8000 rpm I have a set of solid pins that weighed in at 16.6 is this enough to get back to clicker 3 and around 7800/7900 or is clicker 2 ok I am tired of pulling this thing apart
 

·
Registered
Joined
·
527 Posts
16.2 to 16.6 will not yield any noticeable difference.Clicker 2 is OK. If you feel that it is overreving go to clicker 1. Clicker 2 works good on the mach and if 8000 rpm is only at the end of a very long run then that is also ok.
 

·
Registered
Joined
·
259 Posts
Discussion Starter · #3 ·
player said:
16.2 to 16.6 will not yield any noticeable difference.Clicker 2 is OK. If you feel that it is overreving go to clicker 1. Clicker 2 works good on the mach and if 8000 rpm is only at the end of a very long run then that is also ok.
[snapback]717046[/snapback]​
I will leave it for now thanks
 
1 - 3 of 3 Posts
Top