Ski-Doo Snowmobiles Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
99 Posts
Discussion Starter · #1 ·
INSTALLED new cudney adjustable pins today on my 05 with updates and set them up to be approx. 16.5 grams each, question is do you guys add loctite to the set srews that you put into the pins or just tighten them against each other. put loctite on the the set srews holding pins in place, but not on the set screwa inside the pins. thanks for any help------------
 

·
Registered
Joined
·
2,146 Posts
I have installed the pin weight screws and just tightened them against each other and were fine,but the pin in the lever arm I used permanent loctite,the kind that needs heat to unlock.
 

·
Registered
Joined
·
1,327 Posts
I always blue loctite both tiny set screws(inplace of cotters) and the weight allen screws in end of pins....never had any probs.

personally,i would always loctite ALL bolts,screws or anything within the clutch...cause if one thing comes out,your clutch is done!

d.
 
1 - 3 of 3 Posts
Top