Ski-Doo Snowmobiles Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
99 Posts
Discussion Starter · #1 ·
Does anyone know the oem spec for 2003 800 sport? (all shocks)Valving, gas, springs etc

I like the position sensitive for the studders, but this doesn't work so well in big stuff. Naturally anything is give/take, but would like to keep the studder bypass valve for canada trips, but don't want to break it in half if I hit a bad trail.

In short, a touch "stiffer" than stock in the rear(s), but not a pogo stick.

Any experience is much appreciated.

Thank You
 

·
Registered
Joined
·
485 Posts
crafty said:
Does anyone know the oem spec for 2003 800 sport? (all shocks)Valving, gas, springs etc

I like the position sensitive for the studders, but this doesn't work so well in big stuff. Naturally anything is give/take, but would like to keep the studder bypass valve for canada trips, but don't want to break it in half if I hit a bad trail.

In short, a touch "stiffer" than stock in the rear(s), but not a pogo stick.

Any experience is much appreciated.

Thank You
[snapback]747624[/snapback]​
What?????????????? are you talking about????????
 

·
Registered
Joined
·
392 Posts
Look for a post by tweener on rebuilding those shocks, I think he welds up two of the bypass holes to make it a bit stiffer.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top