Search Results for ‘wiring’

Hey guys so I had a quick question. What’s the best way to wire up a led light bar to an 07 summit 800r. the headlights are led so can I tap into them? I was thinking of tapping into an accessory blank but if I did would I have to add a relay? I don’t wanna blow anything. Jutst let me know the...

Was wondering for those guys that are running a headlight delete on their gen4 and are using a small led light,how are you wiring it.i have one buddy who has it wired to the high/low beam switch so he can turn off and on.other ideas are appreciated. It's on a 18' summit sp with shot start so no...

recently purchased my first snowmobile in may 2020, i've regularly started the sled every few weeks over the summer. i found one time it wouldn't start and kept hearing the starter relay clicking therefore, tested the battery found it to be dead and replaced it (pull start does work and sled...

Folks. The "Neglected-Abused / Rolled down the ski hill / 2014 Skandic Rebuild" is nearing the end. Now trying to track down some open wires and a few shorts. I have the wire diagram from the Parts Website and I have the full Service and Operating Manuals. These give block diagrams, but not...

Has anybody come across one of these yet? Took the plunge to order a 2021 Expedition SWT 900ACE and would like to figure out how to add a few items ahead of time. Will be ordering the service manual soon but figured I'd ask about the wiring diagram first.

I'm putting a 1991 mach1 engine into a 1994 formula stx. Some of the wiring doesn't match up. Does anyone know what wires go together? Thanks.

So I have a burned headlight, no big deal right? I thought so too. I go to changed it out, and discover that the female plug portion that plugs to the light bulb itself is partially melted and burned. Now the issue is? How do I go about changing that short of buy a whole new harness assembly...

I know this has been discussed quite a bit on here but I'm looking for some clarification. I've been having intermittent starting issues with my sled. It starts with the solenoid clicking a couple of times but then starting and progresses to clicking and not starting. I put a new battery in back...

Good evening. Trying to get my sled back on the snow, but having issues. The sled is an electric start and cranks fine, but no lights, dash, or start. Friend brought over Candoopro and we got a code of P0608. So, I looked that up and it says: P0608 is bad wires/shorted TPS or ERave position...

The engine light on my 07 mxz x is blinking for some reason. I have no Idea why because my sled, as far as I can tell, is running and starting up fine. It blinks at a rate of about once per second. I`m thinking it could be a wiring issue on a sensor or something because of the fact hat nothing...

so i got a 1995 grand touring chassis formula 500 hood and a 670 engine from a 1993 mach 1, im trying to wire up the lights and gauges properly but cant get it it the hood connection or where the three wires connect to the break and lights. at the bar any help sorting it out be greatly appreciated

Hi guys, Just wondering if anyone has a picture of the battery install on a 04-07 Rev 800. I am installing an previously enjoyed Estart and I am not sure where the second wire from the 30A fuse holder goes ( one side to + battery post and other?). Also where does the ground strap from the...

So I recently had a fuel leak plus Electrical short that started a fire in my engine compartment. Luckily it didnt melt my Oil, Coolant or Fuel tanks. I Have removed everything from my sled and cleaned it. Ordered a new Wiring Harness, Resealed my engine and re lubed my bearings while in...

Hey all, I am working on my 2003 Ski Doo MXZ R. Before i got it someone rolled it and had come some replacement wiring. When I went to install a heated thumb warmer I noticed that when the sled is running or connected to an external 12 v battery the entire sled becomes energized. I'm thinking...

My 96 formula z was a 583 now had a 670 in it.Everything used to work great now not so much. No gas gauge, no temp gauge no hand warmers. But my tach and lights work. Bad ground? Bad fuse/broken power wire?

So I know this has been brought up if I buy a ram rugged mount and a hardwired to my battery what wires go where because they say black and red are positive and green is a Serial ground so what wires do you use thanks

Although I have read a lot of the forums on how to wire up accessories to sleds with out batteries, I would like to start this one to shine some light on running multiple accessories at once... or at least have the potential to. First off, I have 2005 MXZ Renegade 800 HO that I am looking to...

Where is everyone getting power for their lead dog on the 850? Thanks

I need to know where the thumb warmer wires go on my 2016 600rs. Previous owner cut the wires for the thumb warmer which I have replaced. I also need to figure out what to do with the ground wire that attached to the stock handlebars. I put some RSI bars on and there's nowhere to attach the...

Hey hey. Picked up a 1977 Ski-Doo Everest 440/E F/C last year and finally got around to getting this thing running. No spark on mag side. Previous owner was kind of a hack, so I have a bit of mess to fix up. Purchase points, condensers, external coil(one wasn't reading any ohms), battery and I...